Thanks Jeff ChrisL Registered: 020307 Posts: 737 081007 at 05:12 AM 2 Would it be the same as an 855 My book only has the 855s and the flywheel to crank is 200-220 ft lbs and to lube em with SAE30 oil.

The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.

Before 1989, Cummins engines were probably best known for powering medium- and heavy-duty trucks, but in that year, Dodge began installing them in its three-quarter ton trucks.

Although General Motors had been using diesel engines in its light trucks for more than a decade, those power plants did not compare to the heavier-duty Cummins engine.

Fuel System The injection pump gear nut bolts require 125 ft.-lb.

The banjo fittings on top of the fuel and water separator, and on the fuel supply and return lines should be tightened to 18 ft.-lb.

The T fitting on the fuel drain manifold needs to be tightened to 106 inch-pounds.

The fuel filter canister bolts require 18 ft.-lb.

The fuel filter canister mounting nut needs to be tightened to 10 ft.-lb.

The fuel filter drain valve mounting screws need only 30 to 40 inch-pounds of torque.

The fuel tank mounting nuts need to be tightened to 30 ft.-lb.

The injection pump mounting bolts need to be tightened to 32 ft.-lb.

The fuel line fittings at the fuel injectors should be tightened to 30 ft.-lb.

The fuel transfer pump mounting bolts require 9 ft.-lb.

Sensors The camshaft sensor bolt needs to be tightened to 15 ft.-lb.

The accelerator position sensor bolts require only 105 inch-pounds of torque.

The manifold air pressure sensor bolts get tightened to 10 ft.-lb.

The water-in-fuel sensor bolts should be tightened to 15 to 20 inch-pounds.

Miscellaneous Components The retaining bolts for the engine lift hooks require 57 ft.-lb.

The engine control module (ECM) bolts should be tightened to 18 ft.-lb.

The air intake housing bolts need to be tightened to 18 ft.-lb.

The intake manifold air heater relay bolts should be tightened to 40 inch-pounds.

The power control module (PCM) mounting bolts require 35 inch-pounds of torque.

References Dodge Ram: 5.9 Cummins Liter Engine Torque Specifications Cummins: Company History More Articles N14 Cummins Torque Specifications How to Replace the Intake Manifold in a.

How to Change a 2000 Dodge Durango 5.9.

Why Is My Car Surging Stalling How to Remove the Injector in a Yanmar.

How to Change the Fuel Filter on a 6.7L.

Leaf Group Media About Us Accessibility Terms of Use Privacy Policy Copyright Policy Manage Preferences.

Flywheel Bolt Torque Cummins